Web timer for 145 seconds
As you hold the boat steady beside the banca landing, let the 145 seconds run while you tie a double knot without shifting your attention to the screen. Use the interval to pass the rope around the cleat, form the first knot, then add the second and check that both loops sit flat. Keep one hand on the line whenever boat wake or a coastal breeze makes the hull pull away.
With your hands occupied by the rope, a device in silent mode can remain nearby without interrupting the job. Place it where you can see the display at a glance but where spray cannot reach it. The visual end signal lets you finish tightening the knot before checking whether the interval has ended, rather than loosening your grip to listen for an alert.
If the first knot slips during the pull check, reset the same interval and repeat the full sequence instead of rushing only the loose section. A second run gives you time to undo crossed rope, retie both knots, and test the line under steady tension. When the first attempt holds early, use the remaining moments to check the cleat and keep excess rope clear of the water.
Frequently asked questions
Could tying the boat take longer than this interval in Philippine coastal conditions?
Yes. Rain, a wet rope, boat wake, or a stronger coastal breeze can slow your hands and make a second interval sensible. Keep control of the line first, then restart the countdown after the boat is stable.
What if the double knot is secure before the countdown finishes?
Keep the boat steady and use the remaining time to pull-test both knots. You can also coil the loose rope so it does not trail into the water or catch underfoot.
Cookies policy