Web timer for 160 seconds
You have already rinsed once, but streaks of monsoon mud are still clinging to the soles, so you start 160 seconds again and work on the grooves rather than repeating the same quick splash. Keep the shoes over a drain or outdoor wash area, loosen packed grit with an old brush, and use a gentle stream so dirty water does not spray back onto your clothes.
With another rinse underway, leave the timer tab visible while you scrub from heel to toe. Closing that tab or the browser may stop the countdown or prevent its alert, depending on your phone and browser settings. If you need another screen, switch tabs without closing this one, and glance back before the remaining mud has time to spread across the wet upper.
As you finish the second pass, remember that the signal may also reach family, housemates, coworkers, or neighbours nearby. Keep your phone close and its volume only high enough for you to hear above the running tap. If someone is resting or taking a call, vibration can mark the end without turning a routine shoe rinse into a shared interruption.
Frequently asked questions
What can make this second 160-second shoe rinse take longer after a Philippine monsoon downpour?
Clay-heavy mud packed into deep tread usually needs more brushing, while loose street grit may wash away sooner. Extend the rinse only long enough to clear the remaining grooves, rather than repeating the whole cycle automatically.
What should you do if the shoes look clean before the 160 seconds end?
Stop the water and silence the timer before it alerts people nearby. Use the remaining moment to check the sole edges and place the shoes where drips can drain safely.
Cookies policy