Web timer for 3 seconds
You start the 3 seconds countdown again while holding your identification card against the SSS terminal, giving the reader another moment to register it. Keep the card flat and your hand still instead of pulling it away as soon as the screen changes. The repeated pause separates a missed scan from a second, deliberate attempt without holding up the people behind you.
As you wait for the terminal response, sound may quietly remain routed to headphones tucked in a pocket or bag. That can make an audible signal seem absent even though the countdown has finished. Watch for the visual change on the phone, then check the terminal screen before moving the card; the reader’s message, not the sound in your ears, tells you whether the SSS identification was detected.
During the second attempt, occupy the brief gap by checking that the printed side faces the expected direction and that no other card sits between the identification and the reader. This small task keeps you from staring at changing digits or lifting your hand too early. Once the display confirms the scan, move aside and put the card away where it will not be bent.
Frequently asked questions
What can make an SSS terminal need longer than this countdown to read the identification?
A card held at an angle, moved too soon, or separated from the reader by another card may delay recognition. Follow the message on the terminal if it is still processing when the countdown ends.
What should you do if the SSS identification registers before the countdown finishes?
Remove the card after the terminal shows confirmation; there is no need to keep it against the reader. Stop the countdown quietly if its sound is being sent to your headphones.
Cookies policy