Web timer for 30 seconds
While you keep one hand on your snorkel gear and watch the activity around the reef, a 30 seconds countdown gives you a clear window to rinse the mask after getting out of the water. Swish fresh water across the lens, skirt, and strap while staying aware of companions moving along a Philippine beach or boarding a boat.
As you work salt and fine sand away from the mask, your attention belongs on the folds where grains can remain. A countdown running in a browser tab may continue after that tab slips behind your camera, messages, or another screen, though some phones can delay an alert when the browser is restricted. Keeping the display awake nearby makes the finish easier to notice without interrupting the rinse to check.
While you finish the rinse and keep hold of the mask, consider the people sharing the boat deck, dive bench, or beach shower. Set the phone close enough for you to hear, but keep the alert modest so it does not startle a diver handling gear nearby. If wind and engine noise are strong, use vibration on a stable surface instead of raising the sound.
Frequently asked questions
What can make this rinsing time longer or shorter after a reef swim in the Philippines?
Fine beach sand, dried salt, or sunscreen on the skirt can make the rinse run longer. A mask rinsed immediately with clean water may be ready sooner.
What should you do if the mask is not fully rinsed when the countdown ends?
Continue until visible sand and salt are gone, especially from the skirt folds and strap fittings. If you finish early, stop the countdown before its signal disturbs nearby swimmers or divers.
Cookies policy